Manufacturers

Advertising

EZMotion Z-Wave motion detector

EZMotion Z-Wave motion detector

This EZMotion Z-Wave motion detector PIR (Passive Infrared Receiver) detects the presence of a person in a room. Additionally the actual temperature and the amount of light in this room is detected and made available via Z-Wave.

More details

exc00001

This EZMotion Z-Wave motion detector PIR (Passive Infrared Receiver) detects the presence of a person in a room.

Additionally the actual temperature and the amount of light in this room is detected and made available via Z-Wave.

The EZMotion send information to a controller or any other associated Z-Wave device. Up to 4 devices can be controlled from this unit.

The sensor is a battery-powered device, which is in sleeping state unless an action is detected.

After a programmable sleeping time the device wakes up and sends a status information. After this the unit goes back to sleeping modus.

The EZMotion will give a visual warning on the device and sends a warning to the Z-Wave controller, when batteries need to be replaced.

Batteries can be changed without unscrewing the device from the door or frame.

The unit offers a tampering control and sends an alarm message when tampered.

The device is configurable in terms of motion detection angle and sensitivity or the time-out when the detection will fall back to a no-motion state. Sensitivity can be set from “pet-save” via normal up to “presence” where even a not-moving person in a room is detected by its breathing.

The device needs to be included into a Z-Wave network by a remote control or any other Z-Wave controller.

For configuration of certain behaviour a static controller such as a PC with home automation software or a gateway is recommended.

  • Power :  4,5 VDC (3 piles AAA)
  • Angle de détection :  90° à 10 m
  • Durée de vie des piles :  1 an
  • Headphone :  868,42 MHz
  • Height :  7,9 cm
  • Indicateur :  LED rouge
  • Width :  2.0 cm
  • Longueur :  3,4 cm
  • Portée :  30 mètres
  • Précision de la température :  0.5°C
  • Supported protocols :  Z-Wave
  • Résolution de la température :  0.125°C
  • Operating temperature :  -10°C à 100°C
  • Type appareil :  Capteur Z-Wave